(800) 853-2651
SHOP NOW

seed plate drive

T

TUCKAWAY

Member
My farmall 100 tractor has oil coming out of the inside of the shaft where the bolt is,on the seed plate drive shaft.Is there an oil seal that goes inside with bolt, there is nothing on bolt but two spacers and lock washer. Thanks Tuck
 
The 4 capscrews around the axle hold the seal. Remove them and the seal will come off with the stamped sheet metal retainer.
 
Did you just install this or has it been on and just started leaking? It doesn't seem like there is really any path for oil to come out next to the bolt.

As I recall, the bolt should go through a special flat washer, then the bushing (the part the sprocket pins to) then goes directly into the end of the axle with no other parts in the stack. When bolted in, the bushing should be tightly held to the axle, no wiggle. Some improper assembly or the bolt running loose might create a path for oil to get out.
 
Jim I relpaced the oilseal in the retainer and it fixed that leak. I think I will make a homemade seal for the inside shaft. Thanks for your help. Tuck
 
Maybe an o-ring added in the right place would seal it. You may have to study it a while to decide where it is leaking through.
 
Jim,

They made some changes with the 100 from the Super A. There are two o-rings, one is square in cross section. The sizes are in the parts book. I found the parts on ebay to change my super A and it helped a lot with the leak around the bolt.
 
(quoted from post at 20:56:51 04/30/13)They made some changes with the 100 from the Super A.
Click to expand...
I was not aware of that. Since the parts interchange, it becomes an open question as to which are on any particular tractor.
 
You must log in or register to reply here.

Similar threads

J
IH 154 Cub lo-Boy clutch pressure plate
Replies
2
Views
166
grandpa Love
grandpa Love
H
Farmall Super C
Replies
2
Views
392
rustred
rustred
M
Seed corn
Replies
13
Views
1K
Mule Meat
Mule Meat
J
Huskee model 13AR608P731 replacing lower drive belt
Replies
3
Views
130
jateabatta
J
C
Super C input shaft seal replacement
Replies
1
Views
131
Charlie M
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top