(800) 853-2651
SHOP NOW

Farmall H governor

D

Dan Richardson

Member
The H governor is just about worn out. Is there a common fix without a total rebuild? How about a used one? This tractor is seldom used so I don't want to sink a lot of money into it. Thanks
 
Depends on what is worn out. The thrust bearing is expensive, weights and pins are crazy high priced but I drill them out and use roll pins. Shaft to carb may be worn out also and good used ones should be fine. The rest of it is not all that fussy for a little used tractor except bearings.
 
I will open it up and take a picture and check that the weights are
not sloppy and the spring is hooked up, other than that I don't
check them.
Zach
 
What issues are you having with your governor?
They are pretty simple to overhaul, usually springs & as stated above take up the slop on the weight pivots, and replace the bearings gaskets & bushings.
 
The problem is surging. Checked about everything except the
governor and rebuilt the carb. From the prices I see for a good
used one I don't know if it's worth my time to open it up.
 

I think you can still get all of the internal parts from Case-IH, but there is NOT a rebuild kit. About 14 years ago I got the prices for everything I thought would be needed. Totaled up to well over $600. I went back home without them.
 
You must log in or register to reply here.

Similar threads

S
connecting governor tube to carb on a 1951 farmall h
Replies
7
Views
486
seohiofarmallh
S
A
Farmall H throttle problem
Replies
5
Views
620
allenleschber
A
L
Farmall C263 governor problem
2
Replies
33
Views
1K
used red MN
U
T
F-14 governor boot
Replies
2
Views
269
John M
John M
K
farmall parts & diagrams Farmall H Steering source
Replies
2
Views
207
Janicholson
Janicholson
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top