Lift-All Hose Hookups For Saginaw 3 Point

Sapper55 · Apr 4, 2013

Gentlemen,
I just purchased a new Saginaw 3 point for my '41 H Farmall. The hitch is equipped with 2 cylinders. Unfortunately, I have no hose hookup scheme for the hitch. Would anyone of you happen to have a diagram indicating which hose(s)and ports are utilized. I have no service manual yet, only an I&T booklet that doesn't cover the lift-all. I'm not even sure if the lift-all is functional yet. Sorry for the details. I appreciate any assistance.
Sapper55

Zachary Hoyt · Apr 4, 2013

Assuming it has two cylinders I would run a line from the left front port to the left cylinder and from the right port to the right cylinder. Left and right are seen from the drivers seat. There are other ways to do it too.
Zach

IAtractorKid · Apr 4, 2013

Are you wanting pressure up and gravity down or pressure up and down?

I have hoses from one cylinder going into a T at the other cylinder and hoses going forward from there into a two way valve. I have the lock pins removed in mine so the hitch will still float with a rear blade even though its plumbed with down pressure. Replace those lock pins, and you can really dig with your blade.

Ellis Kinney · Apr 5, 2013

I have a Saginaw also. I ran 1 line from the belly pump back near the cylinders. I then installed a tee with the appropriate fittings. Ellis

Lift-All Hose Hookups For Saginaw 3 Point

Sapper55

Member

Zachary Hoyt

Well-known Member

IAtractorKid

Member

Ellis Kinney

Well-known Member

Similar threads