(800) 853-2651
SHOP NOW

F-12 Sleeve

D

Dave S.

Member
Bought a F-12 engine for the tractor my dad started farming with in the late 40"s. It has new sleeves, pistons & rings installed, water has set in one cyl and pitted the sleeve, piston is fine. I have honed the cyl trying to clean it up, but pits are to deep.

Will sleeves for a C fit? The f-12 has 3 1/8" overbore sleeves. Anyone have a new sleeve and set of rings lying around? Piston has 3- 1/8" Compression
rings and 1- 1/4" oil ring.
 
You could Rice Equipment in western PA. What are the dimensions of the old sleeve? The Farmall C sleeves measured 6.875" long and the diameter at the seal was 3.312". Overbore kits were available for the A,B & C to 3.125". Hal
 
give us a call monday 641-624-2275 we can fix you up new or used with a single sleeve. As well as any other f12 parts you need.
 
You must log in or register to reply here.

Similar threads

N
DC Piston
Replies
2
Views
369
chuck machinist
chuck machinist
C
F-20
Replies
2
Views
258
Mark Poss
M
L
Farmall 656 c263 engine sleeve letter markings meaning?
Replies
3
Views
363
littlefarmer
L
R
To sell or Pitch; STD liner & Piston
Replies
2
Views
500
greg krush
G
R
1600 rings
Replies
8
Views
876
Welding man
Welding man
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top