Topic: Re: 620 drill
|Farmall & IHC Tractors Discussion Forum|
[Show Entire Topic] [Return to Forum]
[Show Entire Topic]
[Return to Forum]
[Add a Reply]
I have no experience with a 620 but we have a 6200, just a little newer version of a 620. They work well for small grains, and i've planted small cover crop seeds and been satisfied too. The front double wheels can fall off if you don't keep the bolts tight where they attach to the swivel (neighbor ran over his wheels with his drill, i've heard of others too but we have never had a problem). I do not think that our 6200 is built as well as our old IH 100. The seed cup levers are thinner, the plastic idler sprockets will break if the chains are too tight, the seeding rate lever is a not as heavy as the one on the 100, and I am not happy with the acre counter. Also, the rockshaft assembly should have some bushings in it on the outer ends instead of just fitting loosely in the stamped frame rails- the rockshaft will deflect over time. Do not let any of this scare you- I think it is still a pretty good drill. But they were a little light for the amount of seed they can carry. They do a good job though. Make sure the opener discs make a V and not a W, which indicates excessive wear and disc replacement in the near future.
Hope this helps,
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2013 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.|