(800) 853-2651
SHOP NOW

row crop 300 transmission rear end oil capacity

If you buy 15 gallons you will have a little left over. Hytran or equiv. The amount is from memory. should be close.
 
I just changed my 300 row crop transmission and rear end last nov. 7 gallons of hytran. 3 drain plugs, I don't know if it's necessary but I was advised to fill the TA through the check plug on the left side of the tractor.
 
I didn't have to do that but what I have done is to push the front of the tractor out of the shed so it is maybe 8" lower than the rear and leave it there for a half hour or so and the TA housing got nice and full of oil.
Zach
 
I have just overhauled the trans in my 300 and replaced the TA. I drained 80-90 gear oil from it. I see some people on here are saying it should have Hy-tran in it. Can someone tell me what the manual calls for or if there is a new rule?
Thanks
 
Seven gal, hy-tran. The original book was printed long before HY-Tran was on the market. IH found out early that gear lube was too heavy to properly lubricate the TA over running clutch. (Ramp & rollers). They went to mixing 10 wt oil with a Torque amplifier additive until HY-tan was marketed with 560 series. The front test plug will fill from rear but takes a little longer to get up to level. The original idea of that front plug (explanation is hidden well in the operators manual) was to fill to that front plug level when the tractor was operated with front of tractor on an incline, working on a stationary pto or belt pulley job.
 
Absolutely use HyTran!!! When I first bought my 300, I changed all the fluids and did what the manual said. The overrunning clutch in the TA went out because I used 80-90. DON"T use anything but HyTran!!!!!!!
 
You must log in or register to reply here.

Similar threads

3
Question on Farmall 300
Replies
11
Views
477
LMack
L
O
Checking Rear End Oil level on 3910 Ford Tractor
Replies
1
Views
243
Destroked 450
Destroked 450
C
Farmall 400 Question
Replies
6
Views
427
C.Amick
C
U
3015 HST transmission hydraulic fluid type?
Replies
1
Views
225
ohiodick
O
Z
Farmall 656 transmission overhaul--should I replace bearings if they seem ok?
Replies
7
Views
488
Greg Reed
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top