(800) 853-2651
SHOP NOW

12 hole weight bracket bolt size for mounting?

F

Farmall-H

Member
I have a 12 hole weight bracket for my 706. I am not near the tractor till this weekend and I am wondering what size bolts are required to fasten the bracket to the tractor? Thanks In advance!

-cole
 
I believe that 3/4 nc is correct. The length will depend on whether the bracket is the steel welded construction or the cast bracket that was used on later tractors. The welded bracket should have a 2 inch or 2.5 inch length. 1/4 Lock washer + 1/2 inch steel bracket plus a minimum of 1 inch of threads into tractor. Check the parts listing on the web for the IH "Official" length.
 
It takes 3/4x2 GR8 NC cap screw and a flat washer, no lock washer, I used to set up new 06 series. Get a reputable GR8 from dealer or industrial supplier. My first try doing this I used a GR5, the customer bought a new 706 & 4-16 rollover plow. It was very heavy on the 3 pt hitch & with 10 weights just kept the front wheels down. He was plowing & the bolts broke with the tractor front end in the air, he couldn't back or go forward because the weights were caught under the tractor at the hitch. Well he had to walk to get his Super M and drag weights out then put it all back together.
 
Really? A '7' and 4x16 (642))?Where i'm from,a 4x16 is usually too much for an 806,sometimes even the 856.But I have seen a few of them (8*6s),but never a '7'.
 
Yes it was a load but he had traction, good black soil along a creek in a river valley. I drove the outfit 3 miles on road new when I delivered it, it was just enough on front end to steer it.
 
You must log in or register to reply here.

Similar threads

7
706 gas choke cable mounting bracket
Replies
2
Views
232
706man
7
K
8n ignition switch bracket?
Replies
2
Views
223
Eman85
E
F
Bolt size for IH 444 424 404 340 240
Replies
5
Views
404
wore out
wore out
P
Cub rear gas tank bolt size?
Replies
4
Views
161
Poonie
P
N
Carburetor mounting bolts size to30
Replies
2
Views
125
Mad Farmer
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top