(800) 853-2651
SHOP NOW

Farmall M MW Live Hydraulic Pump

F

farmall14

New User
Hello,

I am in the process of pulling a M&W pump apart for a Farmall M. Does anybody have a manual for something like this they could email me. It would help a lot to understand it a little better before I go any further and when I have to assemble it again. Any help would be Appreciated.

Thanks
 
lets try that again
a100942.jpg
 
As I racall M. @ W. live hydraulic kits had aluminum housings for the pumps and valve assy. instead of cast iron housings and the aluminum wore quicker than the cast iron pumps and valves. There fore the housings are wore to the point that a repair kit will not hold. The only answer is new cast iron pumps and valve. The cast iron pump and valve assy. should still be avialable maby through Case IH. Good luck and let us know what you end up with. Armand
 
Hello
Yeah anything that shows me a layout of the pump and gives me information on parts and how to pull it apart and get it back together correctly. Again never worked on these before. Thanks for the info so far.
 
If it helps to be encouraging about it, hydraulic pumps from that era are generally pretty simple, just two shafts, two gears, and a bunch of gaskets, orings, and seals. The blowup diagram of the M&W above shows that's pretty much true.
 
Those pumps are prety simple BUT you still have to consider the condition of the casing. If the casing is wore a rebuild kit WILL NOT last and you will need to replace the pump and/or the valve. Been there/done that on both farm tractors and trucks with aluminum pumps and/or valves. Cast iron housings will last longer. By the way what are the problems with your hyd. system and does it have aluminum or cast iron housings? Armand
 
You must log in or register to reply here.

Similar threads

M
  • Question
Farmall M water pump leaks
Replies
3
Views
254
Janicholson
Janicholson
E
Install live hydraulic on a M
Replies
7
Views
368
the tractor vet
T
W
Wiring for Super M With electronic ignition
Replies
10
Views
418
Janicholson
Janicholson
K
Farmall M charging issue - must rev engine for charge
Replies
12
Views
551
Turkeyfoot
Turkeyfoot
T
Who makes a fiberglass tank for Farmall m
Replies
0
Views
266
tstarr
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top