(800) 853-2651
SHOP NOW

Super C Touch Controls

D

Don Mountain

Member
I have a 1954 Farmall Super C with Fast Hitch and the two touch controlled hydraulic lifts in the center of the tractor. The tractor sat for 6 months or so in the barn without being run. The two touch control levers are kind of stiff, but the left one works properly and positions properly up and down. The right one I can't move with the control lever, but I can go down under the hydraulic unit and move the touch control lever easily with a small rod. And then the control lever moves it back easily and the hydraulic arm moves to position just fine. So, the left control moves top to bottom ok. The right one can be moved down with a small pry bar easily, and can be moved back up to top easily by the control lever. But not back down again. So, what is the problem and what do I need to do?
 
If the control rod is bent, it will flex and not push well. If it were mine, I would put effort into moving it through 50 cycles of up down to see if it gets easy when exercised. I suspect it will free up. See if the rod can be straightened or reinforced if it seems bent. Jim
 
Open the boots on the valves under the gas tank(hyd unit)and soak the pistons with blaster, I had one that loosened up, and one I had to take apart and free up. Good wrenching.
 
Disconnect the control lever from the Touch-control. If the lever moves easy its" the spool in the unit. My guess is the lever has rusted and is hard to move. Can be fixed with penetrating oil.
 
You must log in or register to reply here.

Similar threads

M
Farmall C/Super C Liftall Differences?
Replies
2
Views
314
Harold Hubbard
H
M
Searching for Super C Shafts
Replies
11
Views
678
Bull Gear
B
crsutton81
5140 hitch controls
Replies
3
Views
132
crsutton81
crsutton81
R
Need HELP
Replies
3
Views
284
Randyscottsboro
R
D
A govenor
Replies
7
Views
446
gene bender
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top