Spanner wrench socket

Bkpigs · Jan 16, 2013

Des any one know where I can get a spanner socket for the TA units in the 300's? In RPM issue of December it is described as an FES 10-12 spanner wrench tool. Does anyone make these yet? I searched the Internet but found nothin that even gets close. In the following issue it is stated that IH doesn't carry it anymore. Thanks in advance.

Janicholson · Jan 17, 2013

I have several times made one to specific size by using a cheap conventional socket and either welding a correct diameter rod to either side, or grinding the edge to fit the holes in the "nut" Jim

Bkpigs · Jan 17, 2013

Thanks

the tractor vet · Jan 18, 2013

Well they were made by OTC and the only way you can even think about getting one is to have a dealer order it thru there service dept. as if it even still available OTC will only sell it to a dealer on a dealer letterhead . I have ONE and got mine when i bought out a closing I H dealers total service dept's tool inventory . The only thing that i did not get was the sleeve that goes over the splines on the nose of the T/A assembly to help get it thru the seal so you do not tare or have the seal flip on you when you install it as they are a real pain to do. Next question , NO I DO NOT LOAN -RENT - OR LET MY TOOLS OUT .

Spanner wrench socket

Bkpigs

Member

Janicholson

Well-known Member

Bkpigs

Member

the tractor vet

Well-known Member

Similar threads