|
| |
| Farmall & IHC Tractors Discussion Forum |
Topic: Re: SM brake/clutch petal shaft seals
[Show Entire Topic] [Return to Forum]
| Author |
[Modern View]
|
| D Slater
01-16-2013 05:10:29
184.15.8.141
|
Should be the right number. Have recieved parts packaged wrong a time or two from them. NAPA cross over number seal is listed as 1.125 ID and 1.832 OD. Should have some other seal numbers when I make it out to the shop. Up to you on the number of seals, one is all I use there.
National seal # 470045. SK or CR 11171. I prefer the national over the other.
This post was edited by D Slater at 06:27:46 01/16/13.
|
|
|
|
| 47 Bill
01-17-2013 03:18:12
173.166.167.77
|
|
Re: SM brake/clutch petal shaft seals in reply to D Slater, 01-16-2013 05:10:29
|
|
| Thanks for the info. My mistake was that I had not removed the old seal first, as I like to make sure I have the right ones before starting. I had measured the 2 1/8 bore where the washer seats. After removing 60 years of crud, I see the stepped down bore for the seal.
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
