(800) 853-2651
SHOP NOW

rim width

T

tntleake

Member
I want to confirm rim widths. I don't see anything stamped on the outside. Is the measurement inside of bead lip to bead lip
Thanks Tracy
 
Yes. Equal to the widest the bead would be measured side to side if you could get at it when on the rim. Jim
 
If I was to make a guess whats on the 200 rear rims. I would say 10 inch on the left and 11 inch on the other side.
 
I'm sorting through other rims I have trying to match a set of 12" to put those 13.6x38 on and mount to my 460 project.
I measured those on the 200 and best i can tell they are both 12", just differnt brands
 
I made me a giant caliper that I can reach through the wheeels to get a accurate measurement of rims on the older style wheels that you can reach through. Never could get a good quick measurement running around in salvage yards when tires were still on. I found a 9 a 10 and 11 on H's and M. All mixed. All you had to compensate for was the thickness of the rim at bead as I was measureing outside with tire on of course.
 
Good measure from center to center of the rolls that make the bend for the bead will most times be close to the inside measure. Never new a 12 inch wide rim was made like the left one until I saw one a few months ago.
 
You must log in or register to reply here.

Similar threads

P
1750 Flat Repair
Replies
6
Views
344
pcrh
P
Geo-TH,In
Bead was leaning on my rear tire
Replies
13
Views
553
Texasmark
T
T
1936 BR
Replies
2
Views
221
treeman53
T
L
rustred & used red MN
Replies
8
Views
458
Lynerd
L
T in NE
B transmission leak
2
Replies
21
Views
893
gene bender
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top