(800) 853-2651
SHOP NOW

300 hydralics

J

JDnTN

Member
Is there a rebuild kit for a IH hyd distributor
pump? Looked on the parts site here and did not see
one. Does IH have one? What are some hydralic
pressure numbers required to lift a round bale on an
old loader on a tricycle front? Posting for a friend
who has already rebuilt the hydralic unit with store
bought parts. Can parts be bought locally for the
pump? Thanks, Jon
 
Seals, o-rings and gaskets are all that is possible to replace in those pumps. When the bushings wear, the gears wear into the housing and then the pump is shot. Bushings are part of the end plates. You would need to take pump apart and see if it is worth the trouble of replacing seals. Putting a speedy sleeve on a grooved shaft sounds like a good idea except that then you have a shaft that is too large to go through the bushing. Have had shafts built up where seal rides over the years. Sometimes it worked, usually didn't .
 
What pete 23 said. You can get new pumps from places like Steel Wheel Ranch - 785-548-7437. Will cost around $800 +/- if I remember right.
 
You must log in or register to reply here.

Similar threads

H
1955 Utility 300 for sale
Replies
2
Views
300
redforlife
R
F
Ford 4000 Fuel Injection Pump Help
Replies
7
Views
513
FishDuck
F
D
Hiesler power steering
Replies
9
Views
944
D Slater
D
S
My new to me 300 U
Replies
3
Views
317
Janicholson
Janicholson
O
1991 King Kutter 6' Spindle Bearing replacement
Replies
4
Views
293
wore out
wore out
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top