|
| |
| Farmall & IHC Tractors Discussion Forum |
Topic: Re: super c steering
[Show Entire Topic] [Return to Forum]
| Author |
[Modern View]
|
| Rick Remmert
12-03-2012 17:03:07
68.103.4.114
|
Just got mine on my Super C finished this weekend. As Gene told me, replace the bearing on the end of the worm gear shaft. It turns a little play into a lot of sloppy steering. Also, turn the gear on top that the worm shaft runs against 180 deg. in rotation so the worm shaft has a new place to run on. Installed new seals, I did not install the bottom one "upside down" like the manual says. I put it in lip side out or down to seal the oil in. I have driven it and for 5 days now no oil leaks. Also make sure to trial fit the plug in the front that it is screwing all the way against the ball bearing. Mine was not.
|
|
|
|
| blunted
12-03-2012 18:51:47
208.126.138.141
|
|
Re: super c steering in reply to Rick Remmert, 12-03-2012 17:03:07
|
|
| how did you put your worm gear back in for the rite position for as the steering?
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
