Is this wide front from an H or?? Pics

Royse · Nov 29, 2012

This front end was home crafted under a BN.
I'm trying to figure out what it came off originally.
With the front wheels all the way in, they were the same
width as the 13.6 rears that were also custom fit.
Makes me think it would be too wide for an A.
Steering on the back too, but that could have been swapped I guess.
Maybe an H?
Does anyone have dimensions for them or casting number maybe?
Thanks

CenTex Farmall · Nov 29, 2012

It reminds me of a Speeco WFE on a 450LP I have. It's more for light duty and almost looks shop built except you can buy parts for it.

Not a bad looking setup on that B.

Nebraska Cowman · Nov 30, 2012

hard to tell. Not from an H I don't think. Looks
like most of the mounting is home-fabbed. Looking at
the hubs i don't think it's IH. Could even be off a
combine.

D Slater · Nov 30, 2012

May be a aftermarket one for a 340?, 504? with some modification?

rustcollector · Nov 30, 2012

Obviously and "Experimental" and extremely valuable.

TJV · Dec 1, 2012

the hubs and the yellow paint the is showing makes me think a Minneapolis Moline but it would have come off a smaller mm since it looks to be on the lighter side. Just my guess and may be aftermarket also

Royse · Dec 1, 2012

Funny RustCollector!
This whole tractor is/was experimental, although I doubt valuable! :lol:
Some of it was welded on, some silver soldered, some bolted.
I'll take another look at that front end tomorrow and see if I can find any markings.

Is this wide front from an H or?? Pics

Royse

Well-known Member

CenTex Farmall

Well-known Member

Nebraska Cowman

Well-known Member

D Slater

Well-known Member

rustcollector

Member

TJV

Member

Royse

Well-known Member

Similar threads