(800) 853-2651
SHOP NOW

farmall 300 pull plow

Depends on the soil type and how deep. Think thats to much plow for hard pulling ground at full depth.
 
we have very sandy soil were we live at we had pulled a 3 14 ih plow in the spring full depth and it was fine
 
Kind of depends on your soil and how much you plan to plow. If you have easy plowing soil, not too deep and maybe only a few acres, you could get by, otherwise you will be better off with 2x16" or 3x14". Dad pulled a 3x14" in easy plowing with an H with SH sleeves and pistons for a couple of years, and it was all it would handle. He traded for a 460 and then traded the 3x14 for a 3x16".... the 16" was right for the 460.
 
I have a 2-14" IH #8 and it's all my 300 and SH want in my soil. Mostly clay. It will pull in 1st gear turning new sod and 2nd in perviously plowed ground.
a87470.jpg
 
Here's a picture I took just this morning of my 350 getting a workout with a 2x14" IH tumble plow. I was going about 10" deep and in our tight clay it was all the tractor wanted.
a87485.jpg
 
You must log in or register to reply here.

Similar threads

D
70 Plow Hitch
Replies
6
Views
455
Red 56 Binder
R
3
Question on Farmall 300
Replies
11
Views
477
LMack
L
C
Plowing with an A193 plow question
Replies
3
Views
214
Pembroke
P
A
1974 IH 140 manual part number
Replies
5
Views
182
BarnyardEngineering
BarnyardEngineering
B
single front wheel Farmall questions
Replies
7
Views
410
DeltaRed
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top