Anonymous-0
Well-known Member
I read about guys plaining the head on there mortors.dose that help or make it worse.
- Thread starter Anonymous-0
- Start date
rustred
Well-known Member
when the head is warped that is common procedure to have it shaved, .010,.020 or .030 is common.that is all part of a valve job along with every other part to be inspected and replaced as nessesary. it can only be worst when you remove too much meat and the pistons hit the valves. going overboard will also affect valve adjustment.
Anonymous-0
Well-known Member
Thanks put in biger pistons went 3-1/8 domed.alan
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy