(800) 853-2651
SHOP NOW

1066 PTO

R

ridgelane

Member
I've pulled the dual speed PTO unit from the IH 1066 tractor. If I pull the extension shaft out as well, can I put a cover over the hole and run the tractor without the PTO unit in it. Will everything further inside, stay in place without the PTO unit being on the tractor?

Thanks for your help.
 
Yes thats how we got dual speed IPTO for 14/15 series, IH would only ship from factory 1000 RPM IPTO, Then we would order 540/1000 as attachment if we deleted on new order for tractor any IPTO, 766/966/1066 all the same unit.
 
Need to add that IH shipped tractors with delete IPTO had a factory cover plate, we had these laying around for various uses. You might find one at a older dealer yet.
 
I am trying to remove the IPTO housing to replace the 540PTO Shaft. I can only back it off /2 inch and it will not go any further. Manual speaks of a driven shaft that has to be worked off but I do not have enough room to visually see the shaft. Got any suggestions. Need input ASAP. Thanks
 
I am working on my IHC 966 Model Tractor with a broken 540 PTO output shaft. I am trying to remove the IPTO Housing; however, I can only back it off a half-inch. The manual says "you may have to work the driven shaft off of the input shaft; however, I cannot visually see the driven shaft from where I am working and therefore I cannot make it move. Does anyone have any suggestions to help me.
 
Ed, you get better visibility starting a new topic.

As for your issue, all I can suggest is use a bigger pry bar.
 
You must log in or register to reply here.

Similar threads

Ellis Kinney
update on PTO project
Replies
6
Views
366
300guy
3
D
Ford 861 PTO Seal Replacement
Replies
0
Views
112
datacommand
D
M
International 340 Utility PTO Issue
Replies
10
Views
464
militiaman11
M
C
1650 pto Shaft removal
Replies
2
Views
266
Mike(NEOhio)
M
C
John Deere 4640 and 540 pto ?
Replies
8
Views
539
NY 986
N
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top