pto adaptor-overide

Bill Bowen · Oct 12, 2012

How do I remove a adaptor from pto shaft on my M .Trying to mount a #27 mower.Found a set screw and removed also grease fitting.Thanks Bill

Brendon-KS · Oct 12, 2012

You're talking about an over-running clutch, I assume? If so, there is typically a roll pin that goes through the cross hole on the PTO shaft that is accessed through the zerk hole. Once you have the zerk and screw on the opposite side out, rotate until the holes and the pin are lined up then drive it out. Probably full of grease so the pin can be hard to find but it's in there.

BOB HAWBECKER · Oct 12, 2012

+ one

Jim Becker · Oct 12, 2012

After you have the zerk and plug out, hold a nail or similar pointed tool in one of the holes and slowly rotate it. The nail will probably catch on the pin to help find it.

Bill Bowen · Oct 12, 2012

Thanks Brendon found it and got it out.Thanks again Bill Bowen

pto adaptor-overide

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

Bill Bowen

Member

Brendon-KS

Well-known Member

BOB HAWBECKER

Member

Jim Becker

Well-known Member

Bill Bowen

Member

Similar threads