(800) 853-2651
SHOP NOW

O.A.L. of belly pump control rod for 49M.

P

Patrick HMD

Member
I'm needing to blacksmith a belly pump control rod for a 49M. I'm starting from scratch, so I have nothing to measure off of. I'll be using 3/8" 1020 round stock. I'm trying to make one as close to factory specs as possible, and I need an overall length. How far is it from the bottom of the rod to the little nub used for a stop toward the top? That's two measurements I need. [in inches] Can someone help me out?

TIA Patrick
'49M
 
Yea, I see them on ebay all the time too. One on there right now for about 10 bucks. Then you have shipping costs. No, to me it's more fun to DIY. I do have the tools and materials, why not? Piece of cake.

Tractor salvage yards?? I wish!! Non around here. The closest I think are in Corpus Christi and Robstown Texas. That's a couple hours away. There is one on the outskirts of Austin that I visited last month when I was helping my son move. Not much of interest there. Just a very rusty 41M and an 'H'. Mostly JDs and Fords. Farmalls are very rare, mostly JDs in this area. Shame. [sigh]

Patrick
''49M
 
You must log in or register to reply here.

Similar threads

G
Electronic Control of Electric Fuel Pump
Replies
2
Views
285
T.R.K.
T
C
Starter Nose Exploded on Farmall Super M
Replies
7
Views
2K
Tom Dowling
T
B
Re: O.A.L. of belly control rod for 49M.
Replies
1
Views
454
Patrick HMD
P
P
Selective lever controls for belly pump
Replies
9
Views
2K
rustyfarmall
R
P
Belly pump control rod update [DONE]
Replies
3
Views
1K
BigTone
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top