Author	[Modern View]
Farmallb 10-04-2012 12:08:09 67.142.178.26 Report to Moderator	I was told on here to get seal # cr11223. This is for the angle housing that fits on the Cub pto and angles it 45* so as to be able to use a flat pulley. The shaft that I need the bearing seal for measures 15/16ths. The Inside of the seal measures 1 1/16. What do you think?? [Reply]   [No Email]
Haas 10-05-2012 07:12:05 75.200.187.78 Report to Moderator	Re: Seal for Cub PTO angle shaft. in reply to Farmallb, 10-04-2012 12:08:09   The bushing goes over the splined shaft and bears against the bearing inner race and acts as a bearing retainer. The bushing is held in place when you install the belt pulley which is held by the bolt in the end of the shaft. If the pulley is not on there, then there is a sleeve that goes over the shaft and held in place with the same bolt that holds the pulley in place. Go to CNGCO.com or call them up and they should be able to get all the parts you need. [Reply]  [No Email]
Haas 10-04-2012 12:37:13 75.200.186.99 Report to Moderator	Re: Seal for Cub PTO angle shaft. in reply to Farmallb, 10-04-2012 12:08:09   I think you are missing the bushing that goes over the shaft. The seal runs on the bushing. [Reply]  [No Email]
Farmallb 10-04-2012 15:23:28 67.142.178.24 Report to Moderator	Re: Seal for Cub PTO angle shaft. in reply to Haas, 10-04-2012 12:37:13   Can you tell me what to ask for to get the bushing? Thanks for the reply. [Reply]  [No Email]
gene bender 10-05-2012 06:37:06 67.55.227.68 Report to Moderator	Re: Seal for Cub PTO angle shaft. in reply to Farmallb, 10-04-2012 15:23:28   If you dont have the flat pulley get the collor that fits over the splines and fastens with a capscrew and large washer to hold it on and that will help the seal your dealer should be able to get the parts you need. [Reply]  [No Email]
teddy52food 10-04-2012 18:17:27 184.94.175.179 Report to Moderator	Re: Seal for Cub PTO angle shaft. in reply to Farmallb, 10-04-2012 15:23:28   When you put the bushing on the shaft, use a sealer or the oil will leak out between the shaft & bushing. [Reply]  [No Email]