|
| |
| Farmall & IHC Tractors Discussion Forum |
Topic: farmall c governor
[Return to Forum]
| Author |
[Modern View]
|
| indiana george
09-17-2012 20:00:59
76.16.114.221
|
When you install the governor into the housing,do you pack the housing with grease?
Thanks George
|
|
[Reply] [No Email] | |
| NoNewParts
09-18-2012 04:55:22
67.240.145.25
|
|
Re: farmall c governor in reply to indiana george, 09-17-2012 20:00:59
|
| after cleaning, I use some Lucas on the weight pivots and the front plunger
to give it some protection on initial startup.
the thrust bearing, I use a small amount of good wheel bearing grease
if you mean the distributor drive housing of the governor, yes
This post was edited by NoNewParts at 05:05:00 09/18/12.
|
[Reply] [No Email] | |
| gene bender
09-18-2012 02:23:58
67.55.226.162
|
|
Re: farmall c governor in reply to indiana george, 09-17-2012 20:00:59
|
| No it gets plenty of oil from the cam gear.
|
[Reply] [No Email] | |
| Janicholson
09-17-2012 20:10:39
96.24.99.126
|
|
Re: farmall c governor in reply to indiana george, 09-17-2012 20:00:59
|
| You could, but a coating of engine prelube from lubriplate, or just a light coat of grease on moving pivots will do fine and not contaminate the engine oil with thick grease. Jim
|
[Reply] [No Email] | |
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
