Wiring for M

Rod51M · Sep 17, 2012

I would like to replace the heavy guage cable that runs to the starter from the starter button, but I can't seem to find it for sale by itself. Also, I'd like to replace the cable that runs to the rear light, but the price was really high - I guess because of the flexible conduit that it should have around it.

I have seen complete wiring harness sets, but don't need all the others. Any suggestions?
As far as the rear light wire is concerned, what would anyone think just getting a heavy enough guage wire and then placing it in that plastic, split wire conduit that is common now on cars. Not sure of it's name.

Janicholson · Sep 17, 2012

The big wire is certainly available from almost any NAPA, or truck stop/repair store. The gauge should be 00gauge, with soldered on terminals. Shop for parts by description, not by Farmall M Take the old one in for length, not size (go with 00ga.). The other wire can be replaced as noted, and run under the edge of the platform, or in a piece of steel fuel line to keep it from damage where it crosses foot traffic. Stick on wire loom locator tabs will stick to cleaned spots well. Jim

Rod51M · Sep 18, 2012

Thanks for the info. I will pick one up.

Rod

rustyfarmall · Sep 18, 2012

If you don't like the price of the 00, ask for #1 gauge. The original cable size was #2, and #1 gauge is a BIG improvement. The #1 gauge is also a LOT easier to install, and is much easier to route in and around various obstructions for a much neater appearance.

Wiring for M

Rod51M

Member

Janicholson

Well-known Member

Rod51M

Member

rustyfarmall

Well-known Member

Similar threads