Hiniker Cab mounts

TimWafer · Jul 30, 2012

I just purchased a super nice Hiniker 1300 cab off an 806. I want to adapt the mounts so I can put in on my 656 Hydro. Anyone have any pictures of the front mounts, floor and especially the back of the cab where if fits around the 3 point etc.
I have yet to hoist it onto the 656 but can envision some changes to the front mounts. I have all the original filler plates from the 806. Just trying to envision how it should fit around the backside of the 656. Pictures would help a lot.
Thanks
Tim

JJ Viking · Sep 2, 2012

Hey Tim,
I just purchased a Hiniker 1300 cab off of a 666. (I'm looking for
mounts to put it on a JD 4010 - if that's even possible - hoping
4020 mounts will work for 4010, but still trying to locate some.)

I'm not sure if the mounting brackets I have will work for you,
but I have to think they'll be closer than what you have from the
806. I would be willing to sell or trade these brackets if they
would work for you - they appear to be in very good condition.

I could snap a few pics this weekend and get them to you if you
are interested.
Jeff

TimWafer · Sep 3, 2012

(quoted from post at 23:59:41 09/02/12) Hey Tim,
I just purchased a Hiniker 1300 cab off of a 666. (I'm looking for
mounts to put it on a JD 4010 - if that's even possible - hoping
4020 mounts will work for 4010, but still trying to locate some.)

I'm not sure if the mounting brackets I have will work for you,
but I have to think they'll be closer than what you have from the
806. I would be willing to sell or trade these brackets if they
would work for you - they appear to be in very good condition.

I could snap a few pics this weekend and get them to you if you
are interested.
Jeff

Where are you located Jeff? I gave up trying to find the correct mounts and am heavily modifying a set form some AC model so I could keep the 806 mounts for future use. I should finish them today and they seemed to have turned out pretty nice. Still need to fabricate all the filler plates though.
Do you have those as well with your mounts?
Tim

JJ Viking · Sep 4, 2012

Hey, I'm in South Central MN - near New Ulm, MN.

Would you like me to snap a few pics of what I have?

Jeff

TimWafer · Sep 5, 2012

I’m probably going to stick with the mounts I've made at this point, as you are a ways away. I’m in central NY. If I had known a couple weeks ago before I started fabrication, I would have jumped on them.
I still need to fabricate filler plates for the floor, front cowl and especially the rear around the 3 point & hitch controls. Also like to figure a way to access the PTO lever from inside the cab through that plate.
If you have any of those and wouldn’t mind snapping a few pics, they would be appreciated! You could email them direct to me if you want.
[email protected]
Thanks!
Tim

Hiniker Cab mounts

TimWafer

Member

JJ Viking

New User

TimWafer

Member

JJ Viking

New User

TimWafer

Member

Similar threads