H charlynn power steering install

PaulGinMn

Member
I just finished installing power steering on my H useing a char lynn torque generator and a gm pickup power steering pump. It took some work but it works great except my torque generator is leeking some out the front seal. I see they sell oring kits, is there any tricks or special tools needed to replace these orings?
10405.jpg
10406.jpg
 
Be sure and make a mark with a file on the upper and lower half. You want to get it back there on rassembly. Any parts store with O rings should be able to fix you up with the one large one that fails and causes leaking.
You also need to install a "swivel coupling" Has a small amount of side to side and fore and aft play to keep from overworking the TG.
I found one painted green for a JD that was thr one included with the Charlyn kit. Maybe somone else can give you the proper name and source for it.
 
Wayne is catching a good point of probable failure. A metalic wrap, or sheetmetal reflector should be used between the hose and that 1200 degree manifold. Jim
 
I do have a swivel coupleing ahead of the torque motor I made sure that it wasnt bottemed out when I drilled the shaft also. Thanks for the info
 
I am planning on makeing a shield yet, I just hooked up the hoses this morning and found the leak. I also need to wire the hitachi altenator yet. I pull a 2 bottem plow with this tractor in the fall and the power steering is going to make it a joy to plow with.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top