Implements for a Farmall C

Anonymous-0 · Aug 27, 2012

Will any attachments such as discs, cultivators, planters/seeders sold today fit a Farmall C?

FC Andy · Aug 27, 2012

Sure will if you've got the 3 point hitch for it. I think the general concensus is that the old equipment, at least the tillage tools, meant for those tractors works better than what you can buy now, though. -Andy

IH fan · Aug 27, 2012

I don't know of anyone making small pull type implements today, like plows or disks. Your best bet is to watch farm sales or Craigslist for 2x12 or 2x14" pull plows and 6 or 7' pull type disks and front mounted cultivators for a C, Super C, or 200. the aftermarket 3 points for these tractors may not even lift a disk or pull a mounted plow out of the ground. There is also a mounted plow for a non- Fast-Hitch C or Super C that works well if you can find one.

mkirsch · Aug 28, 2012

The original implements are tough to find, complete. They were so complicated and there were so many parts to them, that things would get lost. If you're missing one piece, the whole implement is scrap steel, because finding a replacement part is just about impossible. Everyone lost the same small pieces.

Modern implements are either attached via the drawbar or a 3pt hitch. The only modern implements that will fit on a stock C are the kind that hitch to the drawbar with a simple pin. You can add on an aftermarket 3pt hitch but it's limited in weight capacity, and doesn't work well for plows unless you have very mellow, very consistent soil.

NoNewParts · Aug 28, 2012

pull type implements made for ATV's are out there, and
will be super easy to pull with a C
a little pricey
check hunting catalogs for food plot equipment

best bet would be to find a FastHitch off a SC
not hard to home-brew a 3-point conversion for the FastHitch
and they are very strong

IH fan · Aug 28, 2012

(quoted from post at 07:50:51 08/28/12) pull type implements made for ATV's are out there, and
will be super easy to pull with a C
a little pricey
check hunting catalogs for food plot equipment

best bet would be to find a FastHitch off a SC
not hard to home-brew a 3-point conversion for the FastHitch
and they are very strong

Not an easy task to adapt a Fast Hitch to a C either. I did see a valve for sale on eBay recently, but If I remember correctly, the bosses with threaded holes to mount a F-H on are not even there. You would need to fab brackets to mount, plus the valve and control handle, plus the check valve block for under the seat, plus the hoses... not worth the effort or expense. The guy with the valve on eBay was parting out the F-H one piece at a time, and to find a complete unit would be tough.

Implements for a Farmall C

Anonymous-0

Well-known Member

FC Andy

Member

IH fan

Well-known Member

mkirsch

Well-known Member

NoNewParts

Member

IH fan

Well-known Member

Similar threads