(800) 853-2651
SHOP NOW

240 hydraulic pump

C

caterpillar guy

Well-known Member
A friend has a 240 the hydraulic pump keeps pushing the seal out on the drive shaft. He says that when he uses his rake on the back. Thinks it has something to do with the ground not being flat. This has the fast hitch. Not 3pt.
I asked him if there was movement in the gear shafts or if there was something missing or added that is not supposed to be in the pump. He said no. He will bring it over this weekend.
 
sounds like you excessive blow by, i would check the pump housing and thrust bearings for wear.


Andrew
 
Andrew, I looked at the pump it looked tight in the shaft department. I did talk to John at J.P. Salvage today he said that either the pump or the valve is bad. Try the other valve to the SCV If then the pump works fine it is the valve. And of course if it doesn't then the pump.This is if it had the sensing valve something about 3 gears in there that can go bad.

thanks .
 
You must log in or register to reply here.

Similar threads

A
Teach us about the Farmall 140
Replies
14
Views
930
NawlensGator
N
N
upgrade 240 to have auxiliary pump
Replies
4
Views
398
Jim.ME
J
crsutton81
Farmall SA hydraulic pump
Replies
4
Views
263
BarnyardEngineering
BarnyardEngineering
C
case 830 hydraulic pump replacement
Replies
1
Views
425
jon f mn
jon f mn
R
  • Question
Ford 550 Backhoe Hydraulic noise.
Replies
4
Views
282
RamblerRebel
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top