Installing oil pan on SH

Va Gasman · Jul 2, 2012

I am ready to install oil pan back on SH. I have 2 bolts that are 3/8" longer than the others. Also there is one that is a stud with nut and washer. Where do these special fasteners go? Also i notice in the bottome corners of the block opposite from the cam there are 2 cork like plugs flush with bottom of block. What are these for? thanks, Randy

The Red · Jul 2, 2012

If I recall correctly the stud is on the back center of the oil pan. The two longer bolts would be where the oil pan flares out straight below the generator side. You see those two holes are not directly in the block but stick out to the side a bit.

pete 23 · Jul 2, 2012

The stud goes in center rear and the two long bolts go one on each side of that stud as they reach through that plate the stud goes in and then into the block. Corks are just to plug go no place holes not used in this application.

sflem849 · Jul 3, 2012

(quoted from post at 20:49:36 07/02/12) The stud goes in center rear and the two long bolts go one on each side of that stud as they reach through that plate the stud goes in and then into the block. Corks are just to plug go no place holes not used in this application.

He said the corks were used on the opposite corner from the cam.

How should you install the rubber plug things in a diesel rear main seal retainer?

Installing oil pan on SH

Va Gasman

Member

The Red

Well-known Member

pete 23

Well-known Member

sflem849

Well-known Member

Similar threads