(800) 853-2651
SHOP NOW

H soft plugs (pics)- done! Thanks D Slater

F

FarrviewWest

Member
A big thank you to D Slater for helping me out on this problem. As you can see, my soft plug was shot and needed to be replaced. There was a lot of crud around #4.

This forum is great for beginners like me- thanks!
 
and here is the pics...
a73887.jpg
 
It WAS nasty! That material was packed in tight between the backside of the cylinder and against the soft plug. I spent quite a bit of time scraping and rinsing it out. I bet #4 runs a little cooler now :)
 
Hey Farrview! Take a big whiff of that sludge and report back what it smells like to you...cause we sure all know what it looks like! :D Glad you got it figured out though. Not to bad to fix either. Good work!
 
Glad to help. Suggest you take the cover off the left side of the engine and clean inside and check the condition of the plate on the engine side if you haven't already. Hope the core plug in the front engine block is in better shape.
 
I took the side plate and lower hose off mine and put the pressure washer to it. I moved the wand in and out of the spaces between the cylinders.
 
You must log in or register to reply here.

Similar threads

B
Oil on my Plugs, but WHERE is it From?
Replies
11
Views
389
used red MN
U
W
Ford 9N Spark Plugs arcing at the boots
Replies
11
Views
596
Tom in St. Louis
T
super99
Farmall H Alternator conversion done
Replies
15
Views
1K
rlp in Co.
R
Y
??? Bad Compression ??? 1710 Ford
Replies
18
Views
751
YORT
Y
M
International 340 Utility PTO Issue
Replies
10
Views
422
militiaman11
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top