Splitting the rear of a Farmall Super A, 100,130, & 140

GRAPE-DRANK · Jun 12, 2012

I need want to split the rear of my Super A. Any one have any tips or pictures I can reference?

TWheat · Jun 12, 2012

Search for spittling jack on Tractor Talk. Lots of posts

TWheat · Jun 12, 2012

Or right here on Farmall IH

GRAPE-DRANK · Jun 12, 2012

I was searching for pictures, can't find any.

old · Jun 12, 2012

Split as in where?? Transmission or what?? Hard to help you unless you fill in the blanks. I built a BA a few years back so doing the engine/torque tube/ transmission I can tell you about but the side axle housings I have done a bit bit that was taking off but not going back on

GRAPE-DRANK · Jun 12, 2012

Split at the transmission.

old · Jun 13, 2012

That is a job that isn't all that bad depending on if you have a hoist set up or some such thing. I found that by lifting the engine off of the torque tube that it worked out better and all.

theredshed · Jun 13, 2012

If your spliting it to put it back together.. then split it at the engine bell housing two floor jacks or one floor jack one bottle jack.. under each end. wedges up under the front frame to keep it from tipping side to side. split it there.. Then block up the rear end remove the bell housing torque tube and your ready to go.. if you need to remove the axle housings take them off first before spliting anything

Splitting the rear of a Farmall Super A, 100,130, & 140

GRAPE-DRANK

Member

TWheat

Member

TWheat

Member

GRAPE-DRANK

Member

old

Well-known Member

GRAPE-DRANK

Member

old

Well-known Member

theredshed

New User

Similar threads