H delay lift?

sgtbull · Jun 8, 2012

Is one of the three available ports "delayed"? (I'd guess to raise rear culitivator rigs after the front) If so, which one is delayed?

sflem849 · Jun 8, 2012

Yes, the one that is offset from the other two. Two are directly in line and one is not. It is that one.

Janicholson · Jun 8, 2012

As sflem indicates, Rear most on the left side. Jim

D Slater · Jun 8, 2012

Delay lift valve is needed screwed into the cylinder ,line or cylinder port on liftall to work.

pete 23 · Jun 8, 2012

Slater is correct. This subject has been gone over a thousand times. All lift ports come from same source. The rear one is a delayed drop as you have to push lever farther forward to release the check valve that holds load up and it takes a trained hand to get the feel of that.

addeCNKS · Jun 8, 2012

Dave and Pete are correct, no delayed lift on the rear unless the delay valve is screwed in. I have even seen the rear section begin to lift first, so the pressure distribution is not exactly uniform.

sgtbull · Jun 8, 2012

thanks for the replies.. it had been a while since I had one apart, but I was thinking they shared a common "manifold"

H delay lift?

sgtbull

Member

sflem849

Well-known Member

Janicholson

Well-known Member

D Slater

Well-known Member

pete 23

Well-known Member

addeCNKS

New User

sgtbull

Member

Similar threads