Farmall cub engine rebuild ridge reamer

farmallboy15 · May 29, 2012

Does anyone know where to find a ridge remear small enough to fit a cub bore? about 2 5/8". Also is there anything i should watch out for during the rebuild? How do i prime the oil pump and also are there any bolts for the clutch or anything when spltting or is it just on a shaft (After the engine bolts to the clutch housing are removed can i just slide the engine out)?

Janicholson · May 29, 2012

The reamer should be available at rental stores, A lawn service dealer, or machine shop.
Protect the crank from knicks and keep things clean. Take pictures every 5 minutes. Put bolts into a cardboard sheet ot 3 and label them and keep them in the same holes they came out of.
If it is supported well, yes. Jim

Farmall cub engine rebuild ridge reamer

farmallboy15

Member

Janicholson

Well-known Member

Similar threads