(800) 853-2651
SHOP NOW

International 364 3Pth

P

Phil Tibbetts

Well-known Member
I have a 364 with the optional hydraulic valve and remotes. I can get the 3pt hitch to lift but it will not go down . There is a knob on the right side that says open and shut and one on the left says fast and slow. How do these need to be set for the hitch to work? Also do the position and draft levers both need to be in the rear position for lift and forward to lower? I am new to IH and have had mostly Massey Ferguson tractors. Please help
 
Hi Phil, Draft level always fully forward unless using some in ground implement like plow or harrow.
To use the remote outlet, put 3pt lift lever in the middle of the Up and Down position and turn the Open/Close valve to Close, now if you move 3pt lever in UP direction the remote cylinder should extend and move 3pt lever in Down direction the remote cylinder will retract if there is a load on it(only UP pressure, Down relies on load on cylinder to push hydraulic oil back into reservoir). The Fast/Slow in Fast position allows 6 GPM oil flow to 3pt, in Slow position allows only 3 GPM to 3pt. I would use the Slow position when mowing with a 3pt sickle bar mower. If I saw a ground hog hole approaching by the front of rear tire, I would quickly move 3pt lever Upwards and then drop it again. That would lift the sickle bar up and over the ground hog hole and drop it again making a perfect cut without hitting rocks or dirt.

Hope this helps
JimB
 
That is the opposite of my Massey Ferguson. The draft control needs to be in the full rearward position for normal operation on it.
 
You must log in or register to reply here.

Similar threads

C
3pt hitch goes up and down but will not maintain a position when stopped it goes back up
2
Replies
34
Views
1K
camfire
C
D
Belarus 822 3-Point in Position Control
Replies
0
Views
75
datacommand
D
K
international 656 hydro deceleration valve question
Replies
1
Views
191
tstoub77
T
C
International 1850 Loader. Forks
Replies
6
Views
282
cdd
C
A
Refitting the transmission cover MF240
Replies
4
Views
228
Caryc
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top