(800) 853-2651
SHOP NOW

1951 Super C Hydraulics Question

G

GaryinAL

New User
Hello all,
I am installing a rebuild kit in the hydraulic block of my super c. I can't figure out how and where the Control valve oring (item 31-350672R1 in the parts book) goes in the block. What holds it in place? It didn't have one when I disassembled it. Any help would be appreciated.

Thanks
GaryinAl
 
That o ring fits in a groove on the control spool which there are two of. This would be the small spools that connect to the linkage.
The hyd valve manual advises to install the spools from the rockshaft end of the valve body and after the rear end cover is installed. This will keep you from pushing the spools in too far and damaging the o ring.
The parts picture does not show the control spools because they can not be servised separately.
I just completed this project on my C.
good luck
Dennis
 
(quoted from post at 03:59:03 05/20/12) That o ring fits in a groove on the control spool which there are two of. This would be the small spools that connect to the linkage.
The hyd valve manual advises to install the spools from the rockshaft end of the valve body and after the rear end cover is installed. This will keep you from pushing the spools in too far and damaging the o ring.
The parts picture does not show the control spools because they can not be servised separately.
I just completed this project on my C.
good luck
Dennis
Click to expand...

Hi Dennis. Thanks for the info. That explains it. I thought it went on the spool somewhere closer to the head end of the spool. I had an oring on the other end. Thanks again,
Gary
 
You must log in or register to reply here.

Similar threads

J
IH Super C engine help
Replies
15
Views
637
jaburford
J
J
Help me understand remote hydraulics
Replies
19
Views
508
TheOldHokie
TheOldHokie
M
1952 Super A Hydraulic pump help
Replies
5
Views
294
BarnyardEngineering
BarnyardEngineering
F
Farmall c hydraulics
Replies
1
Views
1K
used red MN
U
H
IH 424 Diesel
Replies
4
Views
502
Heckathorn
H
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top