FARMALL H 3 POINT HITCH

WSJ · May 4, 2012

I want to tow this disc with a 3 Point on my other Farmall H.
Is a 26" Cat 1 tow bar with a 3 Point strong enough to tow this 8' disc?

mike1972chev · May 4, 2012

My vote is "yes".

Is it a GOOD brand of aftermarket 3 point?

mike1972chev · May 4, 2012

Follow up,I know guys who pull IH trailer plows off of their 3 point cat 1 drawbars.

CNKS · May 4, 2012

If you get a Saginaw 3 point, you use the existing drawbar, including the swinging part. However a 8 ft OFFSET disk is too big for an H unless you reduce the angle and go shallow, which it looks like you are doing. I have pulled an offset about that size with a 70 HP JD 3020, it had all it wanted. It was heavier and had wheels for depth control. Actually an 8 ft tandem is all an H wants if you have any depth. We pulled a 6 ft heavily weighted disk with an H in 3rd. The H was loaded.

WSJ · May 4, 2012

(quoted from post at 17:55:44 05/04/12) My vote is "yes".

Is it a GOOD brand of aftermarket 3 point?

Manufacturers Number: 04010100U
Brand: CountyLine®
Hitch Category: 1
Hitch Pin Hole Size: 3/4 in.
Number of Hitch Pin Holes: 11
End Pin Size: 7/8 in.
Lift Arm Spacing: 26 in.
Ball Socket: 7/8 in.
Length: 26 in.

https://a248.e.akamai.net/f/248/908...rSupplyCompany/0288975_set?$prod_det_no_flsh$

CNKS · May 4, 2012

I missed the "other H". So it depends on the strenght of your 3 point. One as strong as the Saginaw, which is overbuilt, will pull it. However, I don't like pulling with a 3 point or fast hitch as it does cause wear.

mike1972chev · May 4, 2012

Backing CNKS up here.

I think he is taking about a 3 point that retains the U bar and swinging drawbar like mine????

Either way,I believe you are GOOD.If it is a GOOD aftermarket 3 point.I watch guys hitch thier plows to the 3 point drawbar on them.A good one is as heavy as the original drawbar,although,SOME are not!

WSJ · May 4, 2012

(quoted from post at 18:30:55 05/04/12) I missed the "other H". So it depends on the strenght of your 3 point. One as strong as the Saginaw, which is overbuilt, will pull it. However, I don't like pulling with a 3 point or fast hitch as it does cause wear.

Here is the hitch on the "other H". I had to remove the drawbar to get the implements on the hitch.

CNKS · May 5, 2012

That drawbar is attached to the frame of the 3 point if I see it right. Thus there is no movement of the 3 point arms etc. Looks fine, just keep the bolts tight.

FARMALL H 3 POINT HITCH

WSJ

Member

mike1972chev

Well-known Member

mike1972chev

Well-known Member

CNKS

Well-known Member

WSJ

Member

CNKS

Well-known Member

mike1972chev

Well-known Member

WSJ

Member

CNKS

Well-known Member

Similar threads