300 pto ?

PeteEllis · May 4, 2012

300 utility PTO engage lever up or down ??
offpsite stops it??

how to adjust the two set screws u nder little cover on rear?

thanks

old · May 4, 2012

Hard to explain how to adjust that since the I_T manual takes up about 1/3 of the page to explain how to adjust it

Janicholson · May 4, 2012

I will post the answer in a minute or so, I is described in the archives. Jim

Janicholson · May 4, 2012

Assuming it has the band type IPTO,and the lever is not bent or linkage out of spec.
There is a mark on the lever base (manual)
that is midway from locked on, to locked off with the button on the handle. If you cannot find the marks, measure the lever travel and put it at 1/2 way.
In this position, adjust the bands (seperately) (under the little peanut shaped cover on the top)
until each is tight enough to prevent rotating the shaft by hand with a channel lock pliers. Then loosen each about one half turn. This will (should) make it free to turn by hand. It should also make it drive, and brake correctly. Make sure you click the lever latch in either position. Running it W/O latching will cause slipping. Linkage slipping, and bent rods are also issues to watch for. Good luck. JimN

PeteEllis · May 4, 2012

thanks guys I thought that was the system but did not know details

Owen Aaland · May 5, 2012

You can compensate some for worn linkage by making the center position just a bit towards the brake side and allowing a slight drag on the shaft in the center position.

300 pto ?

PeteEllis

Member

old

Well-known Member

Janicholson

Well-known Member

Janicholson

Well-known Member

PeteEllis

Member

Owen Aaland

Well-known Member

Similar threads