300 Hydra-touch

MoMike · Apr 23, 2012

I was wondering if IH used special o-rings between the Hydra-Touch valves and the blocks that contain the lines. I have replaced mine twice with standard kit o-rings and had one blow out yesterday while loading manure. Mine has 2 working valves, one to the fast hitch and one I plumbed for the loader. Any advice appreciated.

Janicholson · Apr 23, 2012

Teflon based Orings are available that are substantially tougher. Make sure the two surfaces are gasket free, and flat before assembly. Welding Supply and motion industries should have specialty Rings. Jim

rhtx55 · Apr 23, 2012

You need orings that are made with material will resist oil degradation, Viton or better. A place that rebuild hydraulics will have them or can get them for you.

AJB-830 · Apr 23, 2012

Mike, Have you checked with your Case-IH dealer?I have taken several valves apart and always got o-rings from my Case-IH dealer. I have not had any problems with these. Think they might have an IH part number. Not sure if you can get an exact replacement with a standard o-ring kit. Al

300 Hydra-touch

MoMike

Member

Janicholson

Well-known Member

rhtx55

Member

AJB-830

Member

Similar threads