(800) 853-2651
SHOP NOW

hydrolic pump 1066

A

Anonymous-0

Well-known Member
Pump on my 1066 seems to be wearing out. When i try to raise the disc, or whatever i have behind me, it goes real slow. A lot of times i have to speed the engine up just to get it to move. Would it be best to rebuild the pump or get a different one? Think the factory was a 12 gallon pump, thought about getting a 15 gallon or more. Anyone have any suggestions? Also is a rebuild very difficult for a weekend wrench turner? Thanks for your help.
 
I put a 17 gallon pump on mine and really like it!

There is no rebuilding the silly things; the aluminum housing is what wears out.

Allan
 
The bigger pump is nice BUT the down side is that the filter system was only ment for 14 GPM flow so it will be sucking the bypass open and not all fluid will flow thru the filter. To get the flow thru the filter you would have to get one of them kits that STACK two filters on top of each other.. Myself i did not like them because if ya ever really get the tractor stuck IHMO there is to much chance that it might get ripped off . Around here every once in a while we really stick a tractor or should i say PLANT a tractor . I had my one 706 PLANTED that to get on it ya had to step down.
 
I have a new Imt Hydraulic adapter and filter 1-1/4" in and 1-1/4 out for sale. It’s a 10 micron spin-on. Made in USA by Iowa Mold Tooling Co. Filter # 73052092. It's 9" x5", the filter is incluced. I ordered the wrong size. $30 + shiping.

7236.jpg
 
Pull pump and check oring on the top of pump my 1086 did that had to really keep it reved to raise plows and pulled to change pump found o ring blown changed o ring for pennies and works fine now
 
You must log in or register to reply here.

Similar threads

N
1066 engine overhaul
2
Replies
20
Views
1K
Janicholson
Janicholson
D
12V Sprayer pump flow and pressure question
Replies
9
Views
602
Texasmark
T
G
A C 210 injector pump
Replies
1
Views
202
Dieseltech
D
S
Best Practices for IH Wet Sleeve Engines (886, 986, 1066, etc.)
Replies
16
Views
867
JIM MN
J
mdm1
Hydraulic pump leaks.
Replies
6
Views
348
mdm1
mdm1
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top