756 clutch pedal shaft

flhr62 · Apr 10, 2012

What all is involved in getting the the shaft out that the clutch pedal is on? It's worn pretty bad and I would like to get the slop out of it.

mazemeister · Apr 10, 2012

you mean the stub shaft that the pedal pivots on? if it's the same as the 06 series, which i expect, it is held in place by a nut on the inside of the rear transmission housing. if you can figure out an easier way to get at it than taking the whole rear cover off, let me know... cause i've got a couple 806s to do

the tractor vet · Apr 10, 2012

Ah heck thats easy ya just unscrew your arm and add a foot to it then ya can reach up thru the top link plate . The only way is to pull the rockshaft cover off .

flhr62 · Apr 10, 2012

Thanks, Thats what I was afraid of.

Janicholson · Apr 10, 2012

If it were mine!
I would pull the pedal off and drill a 1/4" hole in the center of the shaft. I would then use a Steel capable hole saw to "machine the stub so it is smaller than original, but moderately round, and straight.
Then I would machine a steel bushing to press fit onto it and weld in place with an OD that was original.
Then I would have the pedal rebushed to fit the new stub. Total time 2 hours if the pedal rebush was done at the same time.
Redrill for a grease fitting and done. Jim

756 clutch pedal shaft

flhr62

Member

mazemeister

Member

the tractor vet

Well-known Member

flhr62

Member

Janicholson

Well-known Member

Similar threads