(800) 853-2651
SHOP NOW

super a overhaul

T

thetractorfreak

Member
having a problem finding an overhaul kit that doesnt say to sn310299. my sn is 310981, did they change something that wont make the kits on this site work?? any help appriciated
 
Gene is correct, but you only have two choices, both with larger sleeves than the standard 3 inch those are either 3.125 or 3.25. The 3.25's will only fit if the block part number is 354898, the others take the 3.125 sleeves. I don't fully trust this site as to serial numbers, and do my own research. Be sure you get the head gasket with the large holes. The SA has a thermosiphon cooling system, the Super A1 has a water pump and smaller holes in the head gasket. If your tractor has had a water pump added, either gasket is ok.
 
Measure the diameter at the oring as gene said, in case someone has messed with your engine. A lot about this is in the archives, mostly correct, if you would care to read them.
 
yeah - I'll second that comment about not trusting serial numbers listed by parts suppliers. Not just on this site, but most others too.

I'm doing a super A and have come across a surpising amount of contradicting serial number info.

If you're in doubt - talk to whoever you're buying it from first - Most places have somebody on site that's more knowledgeable than their catalog/site info would make them look.
 
As been suggested measure your old sleeves. Should be one of these measurements. Hal

3-7/16" dia. at the seal by 7-1/16" in length

3-5/16" dia. at the seal by 6-7/8" in length
 
ive heard also that OEM parts, the O rings mike bigger than some of the other parts places, witch will seal better.
 
You must log in or register to reply here.

Similar threads

D
Part it;keep or sell it?
Replies
14
Views
2K
Leroy
L
L
Super A Oil Pressure
2 3
Replies
48
Views
2K
kshansen
K
flooder1997
allis chalmers wd45
2
Replies
29
Views
2K
flooder1997
flooder1997
D
MF-135 Deluxe with gasoline Continental Z-145 too much white/blue smoke
Replies
1
Views
170
Liquid_wrench
Liquid_wrench
N
farmall m carburetor rebuild
Replies
9
Views
501
ncems1995
N
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top