(800) 853-2651
SHOP NOW

Quick attach- Is this complete?

B

BartO

New User
Hello,

I am new to the club, proud owner of my first tractor, a IH 340 Utility. It has the quick attach system on it. I am looking at buying some 3 point attachments, but would like to pick your brains a little. For the quick attach to work, does the implement need to have an adapter? Would it be to my advantage to switch this over to a conventional 3 point? Any help is appreciated.
 
here is what it looks like, is this complete?
a67137.jpg
 
Not sure if its complete or not, but I would go ahead and use it the way it is. Just make sure those little levers on the lower arms lock into place somehow. Otherwise you're liable to yank something around by the toplink. Looks pretty darn good to me. I wish the 3 pt conversion on my old 340 was as nice as that one. just be careful of the pto shaft if you're using a mower or other pto drive impliment. Could hit the drawbar if it goes up too far. Good luck, but most of all enjoy your 340! I loved mine. Kippster
 
Should add that no adapter is needed just an adjustable 3 point top link that will work with all your impliments. it fastens to those two little ears up top there with a good sized pin or in a pinch a big bolt will work. Can buy them at tractor supply. your hitch looks to be a category one type. Kippster
 
How are those tabs supposed to lock? That is what i have been thinking all along, this thing will work but those need to lock. As of right now it appears to me there is no way for them to lock.

I bought a 3 pt mower last night. The 3 point pins are 1/2" wider at their smallest point than the width of the quick attach arms. I am going to shim the "drawbar" so it widens the arms, now just to lock the tabs down?
 
You must log in or register to reply here.

Similar threads

D
JD 5103 Upper Link issue
Replies
1
Views
128
JIM MN
J
J
Advice needed on adding hydraulic remote for quick attach on industrial loader tractor
Replies
10
Views
620
jacks
J
J
quick attach adpter
Replies
5
Views
898
joe201
J
J
quick attach size
Replies
3
Views
1K
ptfarmer
ptfarmer
P
1953 JD 40 Touch-O-Matic 3-point Lift arm (Single)
Replies
3
Views
358
VicS
V
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top