farmall 230

tom grim · Apr 8, 2012

Anybody have a wiring diagram for a 230? This one wont shut of with key, so it must have a feed from the generator I suspect. Your thoughts?thanks

El Toro · Apr 8, 2012

Your ignition switch may be the problem. Locate the wire that feeds battery voltage to your coil
on your switch. Pull that wire off the switch when the engine is at an idle and see if the engine stops. Alternators can cause voltage back feeding causing the engine to keep running. Your switch may not have a good ground. Hal

Janicholson · Apr 8, 2012

El Toro indicates a backfeed. If it does have an Alternator, put a 3 amp diode in the wie that attaches it to the ignition. Band on diode toward alt. A 10 ohm resistor, or marker light will also work in series. Jim

tom grim · Apr 8, 2012

will check better tommorrow-- hope your easter was nice

farmall 230

tom grim

Member

El Toro

Well-known Member

Janicholson

Well-known Member

tom grim

Member

Similar threads