(800) 853-2651
SHOP NOW

Janicholson

L

ldb

Member
Today, I looked for the small sheet metal dome cover that you described for me, but what I found on top of the pto housing was a small sheet sheet metal dome cover that sat on top of a metal tube that was about an inch tall and half inch in diameter that looks like a breather tube. There was no access cover with a nut. So I'm thinking this must be the clutch operated style, which you said is not adjustable. If this is the clutch style, how would get access to the clutches for replacement and is it a major operation? I'm a shade tree mechanic, but I like to fix things if I can. Can't afford to pay $100. per hour these days. THANKS AGAIN JIM LARRY frm MO
 
The parts are available from CaseIH and Hycapacity and others. It is a simple multi disk clutch based device. A manual is good if you are unsure, a camera is needed to document you tak apart effort such that togetherness can happen. It is a disk style. Jim
 
The over center clutch is adjustable but unless you have one of the later ones it will need to be removed from the tractor and adjusted on the bench. The latest housings had a large plug on top that was removable so that they could be adjusted without removing from the tractor.
 
Thanks for the replys; So many ????????? before i start tearing this pto apart. There is a bell shaped (pto) housing that has 4 long bolts that attaches to the rear axle. I assume that when I take these out I can pull the pto and the housing all out at the same time! I also noticed that there is a seperate seal bearing cover that surrounds the pto shaft with 3 bolts in it. Once I get it out I assume I will be able to see the clutch disks at that time and how would I know if it only needs adj. or replaced? THANKS AGAIN from everbody. Larry (ps) If anybody out there has a manual for a IH460 utility I would be interested.
 
You must log in or register to reply here.

Similar threads

grandpa Love
Nice Farmall A
Replies
16
Views
1K
KEB in GCMS
K
gears
3400 clutch advise
Replies
8
Views
514
gears
gears
8
NH 273 baler hay wagon hitch
Replies
10
Views
432
Destroked 450
Destroked 450
D
350c no reverse.
Replies
3
Views
164
Jim.ME
J
A
Conversion overdrive or swap the PTO shaft?
2
Replies
23
Views
1K
Caryc
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top