Sleeve puller puck size?

johndeeregreen · Mar 14, 2012

I"m having a local shop make a puck to use on my homemade sleeve puller to overhaul a Farmall H, I need to know the dimensions the puck needs to be. I don"t have the tractor near me, so I can"t go measure anything.
Thanks!

rustred · Mar 14, 2012

best is to just give them the sleeve and they will do the rest. the machinest may not trust your measurement anyhow as they are critical measurements. and not everyone has micrometers or even know how to read them.

Rootsy · Mar 14, 2012

.005 to .010 smaller than ID of liner and about .020 smaller than OD of liner. This ensures that the puller doesn't contact the block.

Weld a fine thread grade 8 nut on the bottom with a hole drilled through the puck, don't thread the puck itself. This way if you ever strip the threads you just replace the nut...

GordoSD · Mar 14, 2012

Local IH dealer here has dozens of them > lent mr the right one for a day. I "bought the shop foreman lunch" in return.

Sleeve puller puck size?

johndeeregreen

Member

rustred

Well-known Member

Rootsy

Member

GordoSD

Well-known Member

Similar threads