(800) 853-2651
SHOP NOW

cracked housing on an M

T

truckerlary

Member
I have a Farmall M with the crack in the bottom of the rear end housing. I've found a good rear housing and I'm going to switch out the bad for the good. My question is can I split the tractor between the rear housing and the clutch housing or does it have to split the normal way. I didn't want to remove all the hydraulics if I didn't have to. Thanks Larry
 
removing the hyd. is a small deal. this is a big job. if you are not experienced in setting the differential back up again and measuring everything before dissassembly, then the easiest way is to just get a good welder on that job and life will be easier. no reason a crack cant be welded. have a welder look at it.
unless your talking complete housing with gears included?
 
agreed have it welded or stitched and pinned together, much easier then switching everything.

Andrew
 
The housing I'm getting is complete with gears. All I'm doing is switching housings. The rear that I'm removing has already been repaired but I'm thinking for best value of tractor it's best to replace with a good one. Larry
 
Have removed them with the clutch housing left on the engine but dropped the liftall unit out to remove the 4 bolts and 2 dowel pins inside bolting housings together along with 2 bolts on the outside. If careful to keep things lined up the clutch shaft can be removed with the transmissin.
 
You must log in or register to reply here.

Similar threads

S
Farmall M Axle Housing Gasket
Replies
13
Views
2K
Dieseltech
D
W
40 series SCV housing leaking
Replies
3
Views
220
Weston Bend
W
S
IH 404 Rear Hub Snap Ring Removal
Replies
8
Views
527
used red MN
U
R
Farmall 504 PTO always on
Replies
13
Views
450
Janicholson
Janicholson
Ellis Kinney
Super MTA Issue
Replies
7
Views
478
504
5
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top