Farmall Super C Rock Shaft Arm Question

C. Amick · Mar 4, 2012

I have a front mount grader blade. The lifting cables run from the rockshaft arms to the front of the tractor. I would like to increase the range of movement for the blade. Any ideas on design of a bracket to add to the rockshaft arm tha twould do this? Also, does anyone know of a source for the spring loaded retainer that holds the implement pins onto the rockshaft arms?

Janicholson · Mar 4, 2012

The easiest might be to move the lifting point rearward on the blade, or its push frame. This might require moving the brackets with the pulleys (assumption here) rearward as well. This should be done modestly, as the effect of the change can overwhelm the power of the system, (no lift). If the blade weighs 300 pounds, and the lift point is 1/4 of the way toward the pivot point, it will be about maxed out. Lift assist springs would compensate for that is used. Jim

Stanhoist · Mar 4, 2012

Tractor Photos here C/SC/200 blade IH had a qaud shaped flat iron that pinned in the lift to increase travel, have a 200 with the factory belly blade could send pics?

Stanhoist · Mar 4, 2012

Photo Ad Archives

C. Amick · Mar 5, 2012

I looked in the Photo Ads, haven't found the photo you were refering to yet. I'll search some more later.

Stanhoist · Mar 6, 2012

Photo Ad Archives
C-72

C. Amick · Mar 11, 2012

I did a search in the Photo Ads for "C-72" and nothing came up. What is C-72?

Stanhoist · Mar 12, 2012

Photo Ad Archives, under Galleries, just above Research & Info, C-72 is the factory 6ft blade for a C-230

C. Amick · Mar 13, 2012

Thanks, I found it that time. I was looking in the Photo Ads and not the Photo Ad
Archives. I didn't realize they both existed.

Farmall Super C Rock Shaft Arm Question

C. Amick

Well-known Member

Janicholson

Well-known Member

Stanhoist

Member

Stanhoist

Member

C. Amick

Well-known Member

Stanhoist

Member

C. Amick

Well-known Member

Stanhoist

Member

C. Amick

Well-known Member

Similar threads