(800) 853-2651
SHOP NOW

Lower engine picture, what is this cover called.

Y

Yooper Farmall

Member
Put in new main and rod bearings last night, also put on my freshly painted left rear cast iron center and rim. Wire brushed all the nuts, half nuts and bolts and painted them up.

I'd like to get a new gasket, but I need to know the name of the part it seals up. In the picture, on the left hand side which is the rear of the engine block, there is a cover with 1 oil pan stud that I needed to remove to reach the rear main bearing. There was another cover behind that one. I removed a gasket that I would like to replace but have been searching under "oil pan" and "engine block" on the case-ih parts site and cannot locate the cover.
a63445.jpg
 
Ok, found it, a crankshaft rear oil retainer plate gasket and a crankcase rear dust seal gasket. Thank you for the suggestion.

Put in the new bearings, tested the clearance as we went, pretty much .002 clearance with all 7 bearings, I'm hoping for great oil pressure!
 
In the bottom of the engine block, covered by the oil pan are 2 holes that are plugged with cork. What are they for and why the cork?
 
Check the shaft clearence in the oil pump. Have seen many shafts worn and letting oil pressure escape there.
 
You must log in or register to reply here.

Similar threads

B
450 antifreeze in oil
Replies
7
Views
690
used red MN
U
S
Rear Engine Oil Leak on Gas IH 674 (C-200 Engine)
Replies
17
Views
649
Ozlander
O
S
IH rear main seal leak? IH 444
Replies
6
Views
659
MARK ROBKE
M
J
Rear main seal
Replies
0
Views
162
jerryf609
J
W
What Horsepower Is This Briggs Engine
Replies
1
Views
430
RandyC
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top