(800) 853-2651
SHOP NOW

2 point 2 bottom plow

4

460anger

Member
Bought a set of 2 point hitch 2 bottom plows for my Farmall Super C. Couple questions.... Not sure what model they are, it has the 2 piece points with the plow chief point. Does not have the depth wheel on the side. I bought a 3 bottom set that does have the depth wheel. Would like to install it on the 2 bottom, does anyone have a picture of the way this goes on, as the bolt hole spacing is a little different from the two?
Thanks.
 
This is a C20 fast hitch plow. The C20 is the only 2-14"plow my FCI-2 fast hitch implement manual shows. It doesn't have or need a depth wheel. Depth is set with the fast hitch. I let it go as deep as it wants, about 6-7".
a62613.jpg

a62614.jpg
 
I remember from when Dad got his C-20 new in 1956, the book showed a guage wheel as an option. I can't tell you if it was the same wheel assembly as for the large point 3 bottom though. I never saw the need for a guage wheel, and we had hills and uneven ground in places.
 
My dad wore out the Plow Chief wings on a C-20 plow and he never used a gage wheel. Set the depth using the depth stop on the hydraulic cylinder. Like others have said a gage wheel simply is not needed.
 
You must log in or register to reply here.

Similar threads

C
Adjusting an A193 plow
Replies
12
Views
527
BarnyardEngineering
BarnyardEngineering
M
Sickle Bar and Plow ID
Replies
16
Views
524
mainer76
M
F
Little Genius trip plow
Replies
8
Views
721
DaveBN
D
B
Farmall Fast Hitch Plowing
Replies
10
Views
988
Absent Minded Farmer
Absent Minded Farmer
W
Allis Chalmers 3 bottom Roll-Over Plow
Replies
5
Views
453
Skyhighballoon(MO)
Skyhighballoon(MO)
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top