Cam shaft bearings in a super c engine 123

James R. Christophel · Feb 18, 2012

I am re-building a farmall super c; I pulled the camshaft out and started to look for the cam shaft bushings. It appeared to me that there were no bushings on this camshaft at any of the three bearing points. Can anyone inform me as to what type of bearing or bushing is supposed to be used in that area and where to purchase these items. I called my local case international dealer and he said that the drawings they have do not show any bearings and bushings either. thank you for your input.

pete 23 · Feb 18, 2012

There is no bushing in block for camshaft, however a replacement block would have a front bushing only and same as used in a C-153 from what I can figure. I have known some old engines swapped out due to worn blocks but there is no reason you could not get it line bored and bushings installed.

gene bender · Feb 18, 2012

There are no bushings so just install the cam back and use it ive torn down and refreshed many of them and have never seen any need to worry about tht area. Just make sure you get the timing marks lined up correct or you will have problems this also uncludes the gear that runs the gov. You do need to check the oilpump and make sure the bottom plate isnt warped causing weak oil pressure.

Cam shaft bearings in a super c engine 123

James R. Christophel

New User

pete 23

Well-known Member

gene bender

Well-known Member

Similar threads