(800) 853-2651
SHOP NOW

Super A head gasket confusion

J

Jason S.

Well-known Member
Ok...I"ve searched the archives and it"s clear as mud...lol.My super a has the C123 block with no water pump...and somebody has installed 3.25" sleeves and pistons.Which head gasket on this site is the correct one?...or a part number for the correct one?
 
If that tractor has 354898R2 on the engine block
Napa may have the head gasket. Super C's also used that block. Hal
 

it does have 354898r2 on the block....by the serial number on the tractor it appears to have built in 1954 if that makes any difference.
 
No water pump means large holes in the gasket. Water pump means small holes. Use the part number for a Super A, not a Super A1, which had a standard water pump. The size of the pistons does not matter. The block number does not matter either, in your case. Only the lack of a water pump matters.
 
I understand the large hole gasket for thermo siphon and small hole for water pump..but i didnt know if the cylinder bore made a difference or not.I didnt know if the C113 gasket would hang over into the bore since it's now .25" bigger.
 
You must log in or register to reply here.

Similar threads

C
1953 Super H water in oil
2
Replies
25
Views
1K
used red MN
U
C
H head gasket set
Replies
5
Views
306
gable
G
B
450 antifreeze in oil
Replies
7
Views
703
used red MN
U
T
Engine Identification and gasket choice
Replies
5
Views
372
Sean in PA
S
M
48 B Water flowing directly into crankcase (>2 qts/min)
Replies
18
Views
957
cushman
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top